> Draft Equipment >

Bevlex 200 Thick Wall Beer Line - 3/16" ID x 7/16" OD (per foot)
Bevlex 200 Thick Wall Beer Line
 
If the taste of your beer and the operation of your draft system is important to you, this is the only beer tubing you should consider. It's special dual-durometer construction combines a low extraction inner contact surface with a flexible outer layer for excellent kink resistance and taste protection properties.

What size line for my kegerator?

3/16" ID line is the most common hose line. It provides the needed restriction. To install on 1/4" barbs just heat the hose in hot water.
Price: $0.75

Availability: Usually Ships in 24 Hours
Quantity:

Features
 

Bevlex 200 Thick Wall Beer Line



  • 3/16" ID x 7/16" OD

  • Sold per foot

  • 2.2 P.S.I restriction per foot

  • Major Brewery Approved

Instructions
National Sanitary Foundation NSF 51 Listed Crystal Clear, Tasteless, Odorless Super Flexible - even when cold FDA Approved Super Smooth bore reduces foaming May also be used for gas line

Average Customer Review: 5 of 5 Total Reviews: 14 Write a review.

  2 of 3 people found the following review helpful:
 
Great product but... October 2, 2015
Reviewer: Lance from Torbay, NL  
This beer line is great and I highly recommend it but the resistance is definitely NOT 2.2 PSI per foot. It's a lot less than that... I would say a pressure drop of 2.2 PSI per METER is more accurate.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Quality Update to Beer Lines March 20, 2015
Reviewer: Sean Brownridge from Waterloo, ON Canada  
I finally got around to replacing my beer lines. I didn't notice much of a flavour difference but they are definitely cleaner. Not being too expensive I'd have to recommend replacing beer lines at least every 1-2 years as an easy way to ensure you're getting the most out of your beer.

Was this review helpful to you?

  1 of 2 people found the following review helpful:
 
No issues May 9, 2014
Reviewer: Alex C-M from Ottawa, Ontario  
Ordered 40' of Bevlex.  First time using using this stuff and it was great to work with.  Easy to clean, easy to cut, easy to install on QD's.

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
Better performance April 23, 2014
Reviewer: Paulster from Milton  
Upgraded my old lines to new ones using this stuff and there is less foam for sure (same length).  Zero taste, and not hard to get on to 1/4" barbs at all.

Was this review helpful to you?

  3 of 3 people found the following review helpful:
 
Nice! October 11, 2013
Reviewer: Ryan Goodfellow from Montreal, QC Canada  
This is some heavy duty stuff. It works great! To attach it to my ball lock disconnects & shank tailpiece, just heated with warm water to open it up a bit.

Was this review helpful to you?

View All Customer Reviews