> Draft Equipment > Carbonating > Regulators > Micromatic Regulators > Micromatic Secondary Regulators >

Micromatic 1-Way Secondary 1-Gauge Low Pressure CO2 Regulator (15PSI) [8011-15]
Micromatic 1-Way Secondary 1-Gauge Low Pressure CO2 Regulator (15PSI) [8011-15]
 
Alternative Views:


Manufactured in the USA, this Micromatic, 1-Way Secondary Low Pressure CO2 Regulator is NSF Approved, including use by all major breweries. .

This secondary CO2 regulator has a brass body that comes equipped with a 3/8" OD barbed inlet.

The regulator has a "shut down" safety system (blow off at 55 to 65 PSI). High quality and highly accurate gauge. All right hand (RH) threaded ports.

This 'Low Pressure' regulator is equipped with a 0-15 PSI gauge opposed to the standard 0-60 PSI gauge traditionally found on a regulator.

The bonnet is made out of Red Painted Forged Aluminum and it is approved for use with CO2.

Secondary regulators are designed to further reduce pressure from a primary regulator to a proper dispensing level. Attaching a secondary regulator to your dispensing setup allows you to easily regulate the pressure of each keg individually.

The outlet is a 3/8" OD barbed gas shut-off valve (Right hand thread).
Price: $88.99

Availability: Usually Ships in 24 Hours
Quantity:

Features
 

Micromatic 1-Way Secondary 1-Gauge Low Pressure CO2 Regulator (15PSI) [8011-15]

Features
  • To protect dispensing systems each regulator has a built-in high volume external safety relief valve factory set to relieve at 55-65 PSIG.
  • Secondary regulators are designed to further reduce pressure from a primary regulator to a proper dispensing level.
  • Forged brass body for greater durability. Body has enough mass to serve as a heat sink to help prevent freeze up. Can handle Co2
  • Flow control inlet filter
  • Enlarged CO2 port for high volume
  • Aluminum Bonnet
  • 3/8" OD barbed inlet (Right hand thread)
  • Body parts are 1/4" NPT (Right hand thread)
  • 3/8" OD barbed gas shut-off valve (Right hand thread)
  • Working Pressure Range 0 - 15 PSI
  • Front loading seat assembly is easily replaceable in the field
  • Comes with wall mounting brackets
  • 0-15 PSI low pressure gauge (Right Hand Thread)
Dimensions:
  • 4 1/2" Wide
  • 7 3/8" Tall

Share your knowledge of this product with other customers...
Click here to write a review