> Brewing Equipment > Grain Mills >

New!  Malt Muncher Three Roller Malt Mill
Malt Muncher Three Roller Malt Mill
 
Alternative Views:


The mill breaks down the malted barley into tiny pieces so that the mashing liquid can easily seep into the middle of the barley. This process is necessary because it allows the starch within the endosperm of the barley to ferment and create the beer flavour as well as its alcohol content.

While home brewers can opt to grind the malted barley with a kitchen mortar and pestle, the process is very time consuming as you need to pound large batches of barley to create a substantial amount of beer. Thus, home brewers rely on a machined mill such as the Malt Muncher Three Roller Malt Mill.

This mill is built to last and is sure to hold it's own over a lifetime of use. The three rollers are made out of cold rolled steel, where as the body is constructed out of 6061 Aluminum with hardened steel bearings.

Three roller mills draw grains in better and provide improved throughput making them better and more efficient than traditional two roller mills.

The miller also features knurled rollers that can be adjusted on each end to produce evenly crushed malted barley. The roller features an adjustment range between 0" and 0.63". This allows home brewers to pull the barley to the rollers without destroying the hull. An intact hull is crucial for sparging.

It comes with a removable hand crank which can be replaced with a 1/2" drill rotor.

Want more capacity?: Malt Muncher Three Roller Malt Mill Hopper has a capacity of 12 lbs. It is designed to direct grist down towards the mill gap making milling far faster and easier. (Some assembly required)
Price: 189.99


Availability: Usually Ships in 24 Hours

Add a 12 lb Hopper?

Yes Please. [Add 39.99]
No Thanks.

Quantity:  
Features
 

Malt Muncher Three Roller Malt Mill

Details:
  • Rollers are adjustable at both ends allowing for the gap to be adjusted to ensure a uniform crush along the entire length of the rollers.
  • Gap width can be set anywhere between 0" to 0.63".
  • The rollers have a 12 TPI knurl to efficiently pull the grain through the rollers while leaving the hull intact to form an excellent filter bed for sparging.
  • Optimized for use with a power drill. Recommended 200 RPM.
  • Comes with easy to use crank shaft allowing you to crush grain by hand.
  • Some assembly required (attach the handle to the mill). There are no adapters needed to use a 1/2" drill motor.
Rollar Dimensions: 6" Length x 1 1/2" Diameter
Base Unit Dimensions: 7" Length x 3 1/2" Width x 3 1/2" Height
Weight: 8 lbs


Share your knowledge of this product with other customers...
Click here to write a review