> Hardware > Tri-Clover >

Stainless Steel Tri-Clover Rotating Racking Arm - 1.5" TC
Stainless Steel Rotating Racking Arm - 1.5" Tri-Clover
Stop leaving clean, perfectly good, beer in your conical fermenter and always drain from the perfect height with our tri-clover style rotating racking arm. Remove your existing tri-clamp valve and place this rotating racking arm between the tank and your valve. When it is time to rack off, slightly loosen the clamp nearest the tank and use the built in handle to rotate to just about the trub level.

We suggest you assemble the rotating arm and valve in such a way that the arm is pointed in the same direction as the handle on the valve. In this manner you always know the racking arm is positioned in the fermenter.

The arm is 4" in length before the 90° bend, the arm after the bend goes down 4" from installation hole. The units total length is 8 1/4".

Manufactured in 304-type stainless steel with a polished finish.

A PTFE gasket should be placed between the welded in tank fitting and this rotating arm. Because the PTFE is hard and slippery, it allows the rotating arm to rotate in place. A standard EPDM* or silicone tri-clover gasket should be placed between the rotating arm and the butterfly valve and is always kept completely tightened.

*(Ethylene Propylene Diene Monomer (M-class) rubber)
Price: $109.99

Availability: Usually Ships in 24 Hours

Features Sizing Chart

Stainless Steel Rotating Racking Arm - 1.5" Tri-Clover

  • Made out of 304 Stainless Steel
  • For use with 1.5" TC fittings
  • Rotating Arm and Valve

When buying TC hardware it is important to ensure that you are ordering the correct TC fittings. Unsure about TC sizing? Please consult the sizing chart.
Additional Details
Size: Arm Bend Length A: Arm Bend Length B: Total Length: Material: Type:
1.5" Tri-Clover 4" (Before Bend) 4" (After Bend) 8 1/4" (20.955cm) 304 Stainless Steel Tri-Clover 90° Racking Arm

Share your knowledge of this product with other customers...
Click here to write a review