> Brewing Equipment > Mashing >

Sprinkler Head Sparge Arm (26" Base)

Sprinkler Head Sparge Arm (26" Base)

The sprinkler head (11" x 8 1/2") is constructed of stainless steel, our gravity-fed sparge arm is attached to a heavy duty plastic base. By sliding the rotating sparge arm upward or downward within the base, the sparge arms height above the grain bed can be easily adjusted for optimal lautering and reduced hot side aeration.

Price: $38.99

Availability: Usually Ships in 24 Hours

Quantity:

Features

Sprinkler Head Sparge Arm (26" Base)

The sparge arm features a 26" x 4" base, making it ideal for a variety of vessels such as coolers or kettles. Includes 5/16" ID tubing.

Average Customer Review:

4 of 5 Total Reviews: 3 Write a review.

0 of 0 people found the following review helpful:

Good	January 13, 2019
Reviewer: Isa from QC

I've brewed 5 batches and it does the job very well.

Was this review helpful to you?

1 of 4 people found the following review helpful:

Needs Modification	August 11, 2015
Reviewer: Anonymous Person

I had this running great for 5 minutes but then the holes clogged and it didn't work very well. I'm going to increase the size of the holes so it should work better then.

Was this review helpful to you?

3 of 3 people found the following review helpful:

Great Sparge Arm	June 26, 2015
Reviewer: Mark from Calgary, AB Canada

I have a 2 tier system with my round 10 gal cooler mash tun on the top level so I hooked this up to a Chugger pump. First attempt of use did not work so well as I blew the rubber an end cap off the arm due to accidentally opening the pump up full. My fault totally. Used super glue to re-attach the end caps and was more careful on the pump control valve for the second attempt. Worked perfectly! Rotated smoothly and had an even output across the arm above the grain bed. Adjusted the height by adding tape above the plastic base. Very happy with this sparge arm.

Was this review helpful to you?