> Draft Equipment >

Stainless Steel Swivel Nut - 1/4" FFL x 5/16" Barb
Stainless Steel Swivel Nut - 5/16" Barb
 
The swivel nut is a 1/4" FFL (Female Flare Thread) to a 5/16" barb allowing you to attach the swivel nut fitting to any male flare thread. For any metal to metal connections, a flare fitting washer is required.

The part is great for attaching gas tubing to the gas mfl connect. Preferred over barbed ball locks for their larger barb size for a better fit with the 5/16" gas line.
Price: $3.09

Availability: Usually Ships in 24 Hours
Quantity:

Features
 

Stainless Steel Swivel Nut - 5/16" Barb

Everything you need to know about Swivel nuts in 1 minute - Ontariobeerkegs.com

May we also suggest...
UltraFlex 5/16" ID Red Vinyl Tubing (CO2 Gas Line) (per foot) Flare Fitting Washer 1/4" Ball Lock 1/4" MFL Gas Disconnect CM Becker Pin Lock 1/4" MFL Gas Disconnect
Price: $1.09

Add
Price: $0.95

Add
Price: $5.49

Add
Price: $7.49

Add
UltraFlex 5/16" ID Red Vinyl Tubing (CO2 Gas Line) Flare Fitting Washer 1/4" Ball Lock MFL Gas Disconnect Pin Lock MFL Gas Disconnect

Average Customer Review: 4.5 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
 
Work great but don't overtighten! May 30, 2014
Reviewer: Eric Cousineau from Toronto, ON Canada  
I have like 20 of these in use in my keezer system and they work great. They are somewhat easy to warp if you over tighten them like I did. Usually only the connection to the CO2 tank requires super tight connection in my experience. Works great for quick swapping when I hook up my beer gun!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Gas line October 11, 2013
Reviewer: Matthew Marion from Ottawa, ON Canada  
These are great for the gas lines.  The orange flexible line fits on them although not as smugly as the beer line fits the 1/4's but with a clamp it's a very tight seal, no leaks.

Was this review helpful to you?