> Brewing Equipment > Mashing >

Stainless Steel Weldless Cooler Kit (3 Piece)
Stainless Steel Weldless Cooler Kit Spigot
 
Replace the standard plastic spigot on your cooler with this heavy duty stainless steel ball valve and bulkhead cooler kit. Simply removed old spigot and install the kit in the stock hole, tighten the coupler on the inside of the cooler. This will allow for use as a mash tun or hot water tank.
Price: $43.99

Availability: Usually Ships in 24 Hours

Choose Barb Size

1/2" Barb
3/8" Barb

Quantity:
Features
 

Stainless Steel Weldless Cooler Kit (3 Piece)


Optional 1/2" or 3/8" barb for attaching tubing to perform transfers. Inside coupler allows for any 1/2" attachment. Sealing o-ring is high-temperature, food-grade. Maximum usable clearance of about 1" (Minimum 5/8"). Measure your cooler wall before purchase.

Average Customer Review: Average Customer Review: 4 of 5 4 of 5 Total Reviews: 1 Write a review.

  2 of 2 people found the following review helpful:
 
4 of 5 Good but can't get it enough January 19, 2016
Reviewer: JoJacques from Gatineau, QC  
I am currently using this kit on a 5G Rubbermaid cooler (HomeDepot) and it works fine.
Pro: Great quality. Less hassle than going out looking for all specific parts.

Cons: It fits loosely on my cooler. I had to add 2 washers so it fits tight. Although, I can't get it to be tight enough so it woobles and let some hot wort once in a while. Would be nice to be provided with instructions as which parts goes where (inside/outside) as well as the order for install (washers, then gasket, etc.)

I'm giving 4 stars since I might be at fault here.

Was this review helpful to you?