> Draft Equipment > Carbonating > Regulators > Taprite Regulators >

Taprite Primary Co2 Regulator (Poly Bonnet, 60 PSI & 2000 PSI) [T742HP-02]
Taprite Primary CO2 Dual Regulator with a Poly Bonnet
Premium Taprite Primary CO2 Regulator. NSF Approved -- Approved for use by all major breweries. Manufactured in the USA.

Solid brass body with extra long nipple. Regulator has "shut down" safety system (blow off at 55 to 60 PSI.) Permanent Quad-Ring Seal on inlet nipple helps eliminate a source of leaks -- no need to use a new fiber washer each time a tank is changed. Heavy duty UL rated dual gauges. Left hand (LH) threaded ports with CGA 320 shank and nut.

The Taprite regulator has a one year manufacturer's warranty. The bonnet is made from Polycorbonate. The regulator is approved for CO2.

Features an MFL threaded output connection (does NOT include a Stainless Steel Barbed Swivel Nut).

OntarioBeerKegs is an official distributor of Taprite. We offer a one year in house warranty on all Taprite products.
The plastic bonnet on this model is prone to striping (not covered under warranty). We recommend a zinc model if change your pressure often.
Price: $84.99
Sale Price: $80.99
Save $4.00!

Availability: Usually Ships in 24 Hours


Taprite Primary CO2 Regulator (Poly Bonnet, 60PSI & 2000PSI) [T742HP-02]

  • To protect dispensing systems each regulator has a built-in high volume external safety relief valve factory set to relieve at 55-60 PSIG.
  • Internal relief valve opens if the delivery pressure exceeds set pressure by 15 PSIG. This serves as a warning that the seat or diaphragm may be worn and require replacing.
  • Forged brass body for greater durability. Body has enough mass to serve as a heat sink to help prevent freeze up. Can handle Co2.
  • Polycorbonate Bonnet
  • CGA320 Inlet (Left hand thread)
  • Body parts are 1/4" NPT
  • 1/4" male flared outlet with check (Right hand thread)
  • Working Pressure Range 0-50 PSI
  • Front loading seat assembly is easily replaceable in the field.
  • 0-60 PSI low pressure gauge (Right Hand Thread)
  • 0-2000 PSI high pressure gauge (Left Hand Thread)

  • 7 5/8" Wide
  • 7 1/2" Tall

Average Customer Review: Average Customer Review: 5 of 5 5 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
5 of 5 Great Regulator August 12, 2017
Reviewer: Scott from Winnipeg  
Been using this thing for a while. Swapped out the washer when filling my tank for a better one but it has been perfect. Make sure to double check the nuts a few days after as I had one back off a bit and lost some CO2.  (the one with the valve)   After a starsan check it is good to go.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
5 of 5 Can't go wrong May 3, 2017
Reviewer: Doug from Ontario West Coast  
Best upgrade I've made so far! Easy dial-in of keg pressure. Built in O-ring to prevent leaks. Get this unit now, even if your unit supplied reg seems to be working fine. Quality is like day and night. Special thanks and props to OBC and their shipping! I had a reg go bad and ordered on a Friday, arrival on a Monday, beer in hand by 1pm! Thanks!!!

Was this review helpful to you?