> Brewing Equipment >

Weldless High Port Return (12 1/4")
Weldless High Port Return 12 1/4"
This product is perfect for those brewers who want faster cooling and a concentration of trub and hops in the bottom of the kettle. Simply install at an elevated position on your kettle wall, at a higher point than the usual wort level. From there it extends down prior to curving to the side allowing liquid to recirculate forcefully in a whirlpool like manner towards the side. It also enabling you to swivel it in any direction.

The Stainless Steel Camlock Type A in the image is NOT included, it is for display purposes only.
Price: $33.99

Availability: Usually Ships in 24 Hours


Weldless High Port Return 12 1/4"

The following parts are included (please refer to them for additional measurements):
  • Stainless Steel Elbow - 1/2" Female NPT x 1/2" Female NPT
  • Stainless Steel Close Nipple - 1/2" Male NPT x 1/2" Male NPT
  • Silicone O-Ring (Thin 3/4" ID x 7/8" OD)
  • Stainless Steel 1/2" Dip Tube 10 1/4"
  • Stainless Steel 1/2" Male NPT x 1/2" Compression
  • 7-8-ID-Washer
  • Stainless 1/2" NPT Lock Nut
The tube is a total of 10.25" in length with the short end measuring in at 3.25". The product outputs 12.25" below the installation hole, the tube portion of the 10.25" drop is 9.5" in length. For optimal results please install in a position that allows at least 3" of clearance on the bottom of your kettle, in addition when installing please avoid installing it too close to the surface to avoid creating bubbles.

Some Assembly is Required. Tube length without bend 14 3/8

Average Customer Review: Average Customer Review: 5 of 5 5 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
5 of 5 Easy to use January 19, 2016
Reviewer: Richard McAteer from Ottawa, ON Canada  
Quick and easy to install, just what I wanted.  Great stuff!

Was this review helpful to you?