> Brewing Equipment >

Weldless High Port Return (14 1/4")
Weldless High Port Return 14 1/4"
This product is perfect for those brewers who want faster cooling and a concentration of trub and hops in the bottom of the kettle. Simply install at an elevated position on your kettle wall, at a higher point than the usual wort level. From there it extends down prior to curving to the side allowing liquid to recirculate forcefully towards the side in a whirlpool like manner. It also enabling you to swivel it in any direction.

The Stainless Steel Camlock Type A in the image is NOT included, it is for display purposes only.
Price: $35.49

Availability: Usually Ships in 24 Hours


Weldless High Port Return 14 1/4"

The following parts are included (please refer to them for additional measurements):
  • Stainless Steel Elbow - 1/2" Female NPT x 1/2" Female NPT
  • Stainless Steel Close Nipple - 1/2" Male NPT x 1/2" Male NPT
  • Silicone O-Ring (Thin 3/4" ID x 7/8" OD)
  • Stainless Steel 1/2" Dip Tube 12 1/4"
  • Stainless Steel 1/2" Male NPT x 1/2" Compression
  • 7-8-ID-Washer
  • Stainless 1/2" NPT Lock Nut
The tube is a total of 12.25" in length with the short end measuring in at 3.25". The product outputs 14.25" below the installation hole, the tube portion of the 12.25" drop is 11.5" in length. For optimal results please install in a position that allows at least 3" of clearance on the bottom of your kettle, in addition when installing please avoid installing it too close to the surface to avoid creating bubbles.

Some Assembly is Required.

Average Customer Review: Average Customer Review: 3 of 5 3 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
3 of 5 High quality February 23, 2016
Reviewer: Jonas from Calgary, AB Canada  
This is a high quality whirlpool arm but the close nipple barely gives you any thread on the outside of the kettle to attach anything. Also, the o ring that comes with it just bulges out if you try to tighten it any more than hand tight. Also, you may want to installs ball valve on the outside of the kettle to prevent any hot wort flying out of the outlet.

Was this review helpful to you?