> Brewing Equipment >

Weldless High Port Return 8 1/4"
Weldless High Port Whirlpool Return
This product is perfect for those brewers who want faster cooling and a concentration of trub and hops in the bottom of the kettle. Simply install at an elevated position on your kettle wall, at a higher point than the usual wort level. From there it extends down prior to curving to the side allowing liquid to recirculate forcefully towards the side in a whirlpool like manner. It also enabling you to swivel it in any direction.

The Stainless Steel Camlock Type A in the image is NOT included, it is for display purposes only.

Price: 28.99

Availability: Usually Ships in 24 Hours


Weldless High Port Return 8 1/4"

The following parts are included (please refer to them for additional measurements):
  • Stainless Steel Elbow - 1/2" Female NPT x 1/2" Female NPT
  • Stainless Steel Close Nipple - 1/2" Male NPT x 1/2" Male NPT
  • Silicone O-Ring (Thin 3/4" ID x 7/8" OD)
  • Stainless Steel 1/2" Dip Tube
  • Stainless Steel 1/2" Male NPT x 1/2" Compression
  • 7-8-ID-Washer
  • Stainless 1/2" NPT Lock Nut
The tube is a total of 6.25" in length with the short end measuring in at 3.25". The product outputs 8.25" below the installation hole, the tube portion of the 8.25" drop is 5.5" in length. For optimal results please install in a position that allows at least 3" of clearance on the bottom of your kettle, in addition when installing please avoid installing it too close to the surface to avoid creating bubbles.

Some Assembly is Required.

Share your knowledge of this product with other customers...
Click here to write a review