1. Home
  2. Draft Equipment
  3. Duotight Inline Regulator With Gauge - 1/4" (6.35mm) (0-150 PSI)
Duotight Push-In Inline Regulator With Gauge - 6.35mm | 0-150 PSI
Duotight Push-In Inline Regulator With Gauge - 6.35mm | 0-150 PSI

Duotight Inline Regulator With Gauge - 1/4" (6.35mm) (0-150 PSI)

Write a Review
Your Price: $23.79
Status: In Stock
Product Code: KL26918

This Duotight Inline Regulator with Gauge is suitable for gas or liquid. It is constructed out of non corrosive acetyl, nitrile, and stainless components. At the base of the regulator are two mounting points allowing it to be securely attached to wherever you desire.

It features an integrated fully interchangeable gauge that displays pressure between 0 - 150 PSI. You can use it to lower the CO2 pressure going into a keg, or use it to reduce the main water pressure to anywhere between 0-150 PSI.

The intended use for this regulator is to allow for the serving of different beers at different gas pressures. Traditionally this is done by utilizing a Primary and Secondary regulator where you would set different pressures. This compact device is a far cheaper solution that still allows you to set different pressures for your various different beers.

This is done by setting the Primary regulator to the highest pressure desired for your system. From there you run the gas line into a manifold, then install one of these inline regulators after each manifold where you want to decrease pressure. Once installed you can manually adjust the flow with the adjustment knob.

Duotight fittings are designed to work by simply pushing in the compatible tubing.

Inside each fitting are dual EPDM o-rings that provide superior sealing capacity due to having twice the sealing surface area when compared to other push in fittings. This makes Duotight fittings even more reliable and significantly reduces the chance of a leak.

For optimal performance it is recommended that when cutting your tubing it is cut straight, not on an angle, this helps to ensure a complete seal.

Meant to be used with 1/4" OD (6.35mm) Polyethylene Tubing.

Please Note: This product is NOT to be cleaned with chemicals

  • Non corrosive acetyl, nitrile, and stainless components
  • Duotight (Push In) Connections
  • Suitable for mains water pressure
  • Suitable for liquid or gas
  • Can withstand 0-150 PSI
  • 2 Mounting points
  • Integrated interchangeable 0-150 PSI pressure gauge
  • Designed for use with 1/4" OD (6.35mm) Polyethylene Tubing
0 Items