Micro Matic Co2 Pressure Tester [PT1000]

This Micromatic CO2 pressure tester is perfect when you want to ensure that your regulator gauges are 100% accurate.

Having this device installed in your setup provides precision pressures when balancing your system against temperature.

Ideal when used with 0 - 30 PSI low-pressure gauges. Can be calibrated with ease thanks to 'zero adjusting'.

Process:

• Check System for Pressure Leaks Prior to Using Tester. Regulator gauge readings are inconsistent when leaks are present.
• Reset Gauge Pointer to Zero. If tester gauge is not already at zero remove cover form faceplate and place thumb and index finger on each side of the pointer close to the pivot point (hub). Insert a small screwdriver into the slot at the pointer's hub and lightly turn against thumb and finger. Release pointer and continue adjusting until pointer rests at zero. Re-attach faceplate and the tool is ready for use.
• Test Your CO2 Pressure. The tester can be attached to either Sanke "D" or "S" keg coupler with the adapter. Alternatively, it can be attached directly to the shut-off from the regulator or gas distributor.
• Testing From Regulator. Attach the open end of the 5/16" ID vinyl hose (on the tester) to the barbs on the regulator or gas distributor. Ensure that the shut-off valve is open on the attached vinyl hose side and the valve is closed on the coupler adapter side.
• Testing From Sanke Keg Coupler. Attach the adapter to the Sanke "D" or "S" keg coupler. Make sure that the shut-off valve is open on the adapter side and the shut-off is closed on the open vinyl hose side.
• Test the CO2 Pressure. With either of the two prior methods used, apply pressure from the regulator. If the regulator gauge is inaccurate adjust to match the tester's pressure gauge. Replace or repair regulator or regulator gauge if needed. To ensure that no beer enters the tester' gauge, please try to keep the gauge upright while using the Sanke adapter.

---

Details:

• For use with CO2 only
• Accurately measures the pressure of your regulator gauges
• For use with either Sanke "D" or "S" Keg Couplers
• CO2 Pressure Tester Gauge 0 - 30 PSI (resetable to 0)
• Has 2 Shut-offs
• 18 1/2" Overall Length